
hook 2.5 mm
stitch marker
Darning needle
scissors
- Yarn yarn of three colors, yellow, light green, and dark green
- Flower Rod 16 inches long x 0.08 inches diameter (40cm x 2mm)
- Iron wire 6 inches long x 0.02 inches diameter (15cm x 0.4mm)
- Fiberfill
- Hot Melt Adhesive
Lemon
Round 1: Start with a magic ring and make 6 sc st into the ring. Ss to join.Round 2: Ch 1, then make 6 sc st around. Ss to join.Round 3: Ch 1, then (2 sc in each stitch) * 6 times. Ss to join.Round 4: Ch 1, then make 1 sc stitch, followed by 2 sc stitches in the next stitch—repeat this sequence 6 times in total. Ss to join.Round 5: Ch 1, then make 1 sc stitch, followed by 2 sc stitches in the next stitch, and another 1 sc stitch—repeat this sequence 6 times in total. Slip stitch to join.Round 6: Ch 1, then make 3 sc stitches, followed by 2 sc stitches in the next stitch—repeat this sequence 6 times in total. Ss to join.Rounds 7-13: Ch 1, then make 30 sc stitches. Ss to join at the end of each round.Round 14: Ch 1, then make 3 sc stitches, followed by a sc2tog (single crochet decrease)—repeat this sequence 6 times in total. Slip stitch to join.Round 15: Ch 1, then make 1 sc stitch, followed by a sc2tog, and another 1 sc stitch—repeat this sequence 6 times in total. Slip stitch to join.Round 16: Ch 1, then make 1 sc stitch, followed by a sc2tog—repeat this sequence 6 times in total. Slip stitch to join.Round 17: Ch 1, then make 1 sc stitch, followed by a sc2tog—repeat this sequence 4 times in total. Slip stitch to join. stuff the lemon lightly with fiberfill.Round 18: Ch 1, then make 8 sc, and slip stitch to join. Cut a small length of wire, fold it twice, and tie a knot in the middle with a yarn. Put it at the center of the lemon.Round 19: Ch 1, then make a sc2tog—repeat this sequence 4 times in total. cut and hide the yarn with darning needle.
Leaf
Foundation Chain: Start with a chain of 24 st.Round 1: Starting from the 2nd st from the hook, make 2 sc, followed by 3 hdc, 13 dc, 3 hdc, 1 sc, 3 sc in same stitch (forming the leaf tip), 1 sc, 3 hdc, 13 dc, 3 hdc, and finally 2 sc. 1 ss, 1 chRound 2: add wire, work sc stitches all around. Make 1 ch picot stitch at the tip of the leaf. 1 ss, 1 ch. cut and leave a tail.
Assemble
Step 1: After the leaf is finished, wrap the tail around the wire, use hot melt adhesive to secure itStep 2: Take the lemon, wrap the yarn around the wire, use hot melt adhesive to secure itStep 3: Add a leaf on top of the stem, Then add the leaves, and lemons one by one,Step 4: Continue to wrap the yarn around the stem, finally use hot melt adhesive to secure it.
- This pattern is written in US crochet terms.
- This pattern is worked in rounds.
- Use a magic ring to start Round 1.
- Each round begins with a chain 1 (ch) unless otherwise specified.
- Slip stitch (ss) is used to join at the end of each round.
- An additional note was written in Italics.