Make 3 Crochet Daisy Flowers:

Daisy Flower Stamen：

• Start with a magic ring, ch1
• R1:  work 6 sc in magic ring, 1 ss. (6)
• R2: ch1, (2 sc in next stitch) *6 times, 1 ss. (12)
• R3: sc 12 . 1 ss to finish .(12)

Adding Wire to Daisy Stamen:

• Step 1: Fold the iron wire into half
• Step 2: Pick a piece of scrap yarn and tie it over the wire

Join the Two Stamen:

• Step 3: Insert the wire through the green stamen facing up, with the folded part and the scrap yarn resting inside the cup. Pull the tail through the center. Then place the yellow stamen over the green covering the scrap yarn, ensuring they are perfectly aligned.
• Step 4: Starting at any point, insert hook through both stamen and join cream yarn

Daisy Flower Petals:

• R1: (ch4 of the chain, 1 tr, then ch 4, ss 1 into the next st) *12 times; 12 petals in total. cut and weave in ends
• (Note: When the petals are hooked to the 10th flower petals, the stem can be assembled first, or some filling cotton can be added before the petals are hooked and sewn together.)

Make 2 daisy Flower Buds:

• Using the white yarn to make a magic ring, ch3
• R1: 9dc into the magic ring, close the ring, ss, cut yarn, leaving two tails (9)
• R2: Join green yarn, ch 2, hdc 9, ss
• Closing the bud
• R3: ch1, (1sc, sc2tog) *3 times cut and leave a tail
• Add wire (see steps 1 and 2 under the stamen) and insert the tip into the bud, tucking in all the tails, leaving only the green tail visible. Using a darning needle through back loops, close the opening tightly and weave in ends.

Make 2 daisy Leaves:

• Using the green yarn ch13
• R1: start the 2nd sts from the hook, add iron wire, sc11,3 sc in last st, do not turn, working on the other side of the ch, sc11, ss
• R2: ch1, (sc2tog, ch2, 1 ss into the base of the same st, 1 ss in the next stitch,1 ch) *12 times, 1 ss

Assemble:

• Step 1: Align the two buds and the first flower together on the rod, wrap the yarn for about an inch.
• Step 2: Align the second and the third flower, continue wrapping. When joining the flowers, ensure they are aligned on opposite sides for aesthetics.
• Step 3: Then wrap down and add leaves to the right positions.
• Step 4: Until the end of the rod and use hot melt adhesive to attach the yarn ends.